Tojota Lend Kruzer, Amazon, Leksus LX470
+ Identification numbers of the car
+ Controls and receptions of safe operation of the car
+ Options and car routine maintenance
+ The engine
+ Systems of cooling of the engine, salon and air conditioning heating
+ The power supply system and release of the fulfilled gases
+ Engine electric equipment
+ Control systems of the engine and decrease in toxicity of the fulfilled gases
+ Gear change box
+ Transmissionnaja line
+ Brake system
- Suspension bracket and steering
Specifications
Removal and installation of forward shock-absorbers
Removal and installation of the forward stabilizer of cross-section stability
Removal and installation of assemblage of a rotary fist from a nave
Check of a condition and replacement of spherical support
Removal and installation торсионных bars
Removal and installation of the top operating lever of a forward suspension bracket
Removal and installation of the bottom operating lever of a forward suspension bracket
Removal and installation of back shock-absorbers
Removal and installation of a bar of the back stabilizer of cross-section stability
Removal and installation of a jet bar
Removal and installation of a screw spring of a back suspension bracket
Removal and installation of levers of a back suspension bracket
Removal and steering wheel installation
Condition check, removal and installation of draughts of a steering drive
Replacement of protective covers of assemblage of the steering mechanism
Removal and installation of the steering mechanism
Removal and installation of the steering pump
Removal of air from a hydraulic path of system of strengthening of a wheel
Wheels and tyres - the general information
Corners of installation of wheels
+ Body
+ Onboard electric equipment
|
Removal and installation of levers of a back suspension bracket
Components of installation of levers of a back suspension bracket
|
|
1. Components of installation of the stabilizer of cross-section stability are presented on an illustration above.
2. Prop up forward wheels противооткатными boots. Поддомкратьте a back of the car also establish it on props.
3. Prop up the back bridge тележечным a jack.
4. On equipped ABS models liberate electroconducting of the wheel gauge from basic arms on assemblage of the top levers.
|
|
5. Give nuts, throw off washers and take bolts of fastening of the top levers of a suspension bracket to a frame and assemblage of the back bridge (address to an accompanying illustration). |
|
|
6. Give nuts, throw off washers and take bolts of fastening of the bottom levers of a suspension bracket to a frame and assemblage of the back bridge (address to an accompanying illustration). |
7. Estimate a condition of rubber plugs of the lever. Make replacement of defective plugs in the conditions of a car-care centre workshop.
8. Installation is made upside-down. Track, that all fixture has been tightened with demanded effort. A tightening fixture make after car lowering on the earth. |
|
|
|