Toyota Land Cruiser 100 / Amazon, Lexus LX 470

Since 1997 of release

Repair and car operation

Removal and installation of the steering pump

Pump GUR arrangement

Components of assemblage of pump GUR

PERFORMANCE ORDER

1. Disconnect a negative wire from the battery.

If the stereosystem established on the car is equipped by a security code before to disconnect the battery make sure that have a correct combination for audiosystem input in action!

2. Remove air cleaner assemblage (see the Head of the Power supply system and release of the fulfilled gases).
3. Remove приводной a belt (see the Head of Adjustment and car routine maintenance).
4. Get under assemblage of the steering pump drain capacity. Disconnect from a back part of the pump pressure head and returnable lines of a hydraulic path (address to an illustration pump GUR Arrangement). At once закупорьте the open ends of lines in order to avoid hit in dirt system.
5. If the pump is subject to replacement, remove from it приводной a pulley.

Pulley dismantle can be made on a workbench after removal of the pump from the car.

6. Give fixture and take assemblage of the steering pump from an impellent compartment, try not to admit a spillage of a hydraulic liquid on painted кузовные a surface.
7. Components of assemblage ГУР are presented on an illustration Components of assemblage of pump GUR.
8. Installation is made upside-down. Track, that the corresponding fixture has been tightened with demanded effort.
9. Fill in in the tank of the steering pump demanded quantity of a hydraulic liquid of a corresponding grade (see the Head of Adjustment and car routine maintenance), then pump over system of hydrostrengthening of a wheel (see Has undressed Removal of air from a hydraulic path of system of strengthening of a wheel).