Toyota Land Cruiser 100 / Amazon, Lexus LX 470

Since 1997 of release

Repair and car operation


Tojota Lend Kruzer, Amazon, Leksus LX470
+ Identification numbers of the car
+ Controls and receptions of safe operation of the car
+ Options and car routine maintenance
+ The engine
- Systems of cooling of the engine, salon and air conditioning heating
   Specifications
   Antifreeze - the general data
   Check of serviceability of functioning and thermostat replacement
   Condition check, removal and installation of the fan of system of cooling
   Removal and installation of a radiator and broad tank of system of cooling
   Check of a condition of the water pump
   Removal and installation of the water pump
   Check of serviceability of functioning and replacement of the block of the gauge of a measuring instrument of temperature of a cooling liquid
   Check of serviceability of functioning приводного the electromotor of the fan of a heater and its replacement
   Removal and installation of the block and the heater heat exchanger
   Removal and installation of assemblage of the control panel by functioning of a heater and air conditioner
   Check of serviceability of functioning and service of systems of heating and air conditioning
+ The power supply system and release of the fulfilled gases
+ Engine electric equipment
+ Control systems of the engine and decrease in toxicity of the fulfilled gases
+ Gear change box
+ Transmissionnaja line
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment





Removal and installation of assemblage of the control panel by functioning of a heater and air conditioner

Some of cars considered in the present Management are equipped by system of additional safety (SRS), more known as a safety pillow. Before to perform any works near to assemblage of a pillow or a steering column, without fail disconnect system in order to avoid reception of traumas as a result of its casual operation, – disconnect from the battery at first negative, then for a positive wire and wait not less than two minutes before to start service of the components located near to gauges of directed overloads (the Onboard electric equipment see). Isolation and contact sockets of electroconducting of chain SRS are painted in bright yellow colour. It is not necessary to connect any diagnostic devices to the given chain!

Forward heater

Control panel assemblage by a forward heater. Models Land Cruiser


 PERFORMANCE ORDER

1. A thin screw-driver remove two clamps, an ashtray and a coaster.
2. Remove an overlay of the console from the control panel a forward heater (address to an illustration above).
3. Extend the block of management and disconnect electroconducting.
4. Installation is made upside-down.
5. Start the engine and check up serviceability of functioning of a heater/conditioner of air.

Back heater

Control panel assemblage by a back heater. Models Land Cruiser


 PERFORMANCE ORDER

1. Remove a back overlay of the block and include a heater on a maximum.
2. Give three screws and remove the management block (address to an illustration above).
3. Disconnect a socket of electroconducting and a management cable.
4. Installation is made upside-down.
5. Start the engine and check up serviceability of functioning of a heater/conditioner of air.