|
|
Toyota Land Cruiser 100 / Amazon, Lexus LX 470Since 1997 of releaseRepair and car operation |
|
|
Tojota Lend Kruzer, Amazon, Leksus LX470 + Identification numbers of the car + Controls and receptions of safe operation of the car + Options and car routine maintenance + The engine + Systems of cooling of the engine, salon and air conditioning heating + The power supply system and release of the fulfilled gases - Engine electric equipment Specifications Start of the engine from the auxiliary power supply Removal and installation of the storage battery Check of a condition and replacement of wires of the battery Ignition system - the general information and safety measures (petrol models) Check of functioning of system of ignition Replacement of the coil of ignition Check and adjustment of installation of a corner of an advancing of ignition/injection of fuel of the petrol engine Replacement of the module of ignition Charge system - the general information and safety measures Check of a condition of system of a charge Removal and generator installation Check of a condition and replacement of components of the generator Start system - the general information and safety measures Check of serviceability of functioning of a starter and start chain Removal and starter installation Removal and installation of the traction relay + Control systems of the engine and decrease in toxicity of the fulfilled gases + Gear change box + Transmissionnaja line + Brake system + Suspension bracket and steering + Body + Onboard electric equipment |
Engine electric equipment The general information and safety measures The structure of an electric equipment of the engine includes components of systems of ignition, a charge and start. Whereas the given systems have a direct bearing on engine work, they are considered separately from an other onboard electric equipment (such as alarm and lighting fires, monitors, etc.), to placing, a design and to which principles of functioning the Chapter the Onboard electric equipment is devoted. At service of components of systems of an electric equipment it is necessary to observe special safety measures in order to avoid risk of failure of semi-conductor elements, and also for the purpose of prevention of reception of electrotraumas. Remember that the generator and a starter directly are connected to the battery and in case of an overload or short circuit can become a cause of the fire. Try not to suppose hits of hair and free fragments of clothes in приводной a generator belt. Starting electric equipment service, necessarily remove a watch, rings and other metal ornaments. Even at the disconnected battery the category of condensers at casual grounding of their plugs can lead to reception of an electric shock or a strong burn. Do not suppose polarity infringement at battery connection. In structure of such components as the generator, or electronic blocks of management enter semi-conductor elements which can be put out of action at wrong connection of wires. At performance of start of the engine from the external power supply, or connection зарядного devices also observe polarity of connection of wires (the corresponding Section in Introduction to the present Management see). Never disconnect electroconducting from the battery, the generator or the diagnostic equipment at the working engine. Do not suppose проворачивания the engine of the disconnected generator. At all do not make stock-taking of target pressure of the generator by grounding of its plugs. Do not apply to conductivity stock-taking in a chain the ohmmeters equipped manual dynamo-car. At performance of any works on electric equipment service watch, that the negative wire has been disconnected from the battery. Before use of electroarc welding without fail disconnect the battery, the generator and such components, as РСМ systems of a food/ignition in order to avoid risk of their damage. |
|