Toyota Land Cruiser 100 / Amazon, Lexus LX 470

Since 1997 of release

Repair and car operation



Tojota Lend Kruzer, Amazon, Leksus LX470
+ Identification numbers of the car
+ Controls and receptions of safe operation of the car
+ Options and car routine maintenance
- The engine
   - Typical procedures of service of engines
      Preparatory actions and the list of repair procedures which can be executed without extraction of the engine from the car
      Reduction of the piston of the first cylinder in position of the top dead point (ВМТ)
      Check of pressure of oil
      Check компрессионного pressure in cylinders
   + Procedures of service of the petrol engine
   + Procedures of service of the diesel engine
+ Systems of cooling of the engine, salon and air conditioning heating
+ The power supply system and release of the fulfilled gases
+ Engine electric equipment
+ Control systems of the engine and decrease in toxicity of the fulfilled gases
+ Gear change box
+ Transmissionnaja line
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment





Check of pressure of oil

Oil pressure drop can be considered as a sign of that the engine requires regenerative repair. The control lamp of pressure of oil is not among the diagnostic equipment supervising a condition of system of greasing, and only informs the driver on dangerous decrease in oil pressure. Even built in the panel of devices a measuring instrument of pressure of oil, despite the big detail of the given out information, it is possible to consider only as the device of information character. For data acquisition about pressure of oil which then can be compared to requirements of Specifications, it is necessary to take advantage mechanical (not of the electric!) a manometre complete with an exact tachometre.

 PERFORMANCE ORDER

1. Find the block of the gauge-switch of pressure of oil.
2. Remove the gauge-switch and establish instead of it a transitive nozzle for connection of a mechanical manometre. For hermetic sealing of carving connection of a nozzle take advantage of a sealing tape from teflon, or tape ФУМ.
3. According to instructions of manufacturers connect to the engine an exact tachometre.
4. Check up pressure of oil at working on the turns stipulated in Specifications the heated-up engine to normal working temperature. Compare results of measurements to standard requirements. At excessively low pressure it is necessary to estimate degree of deterioration of bearings and-or the oil pump.