Toyota Land Cruiser 100 / Amazon, Lexus LX 470

Since 1997 of release

Repair and car operation



Tojota Lend Kruzer, Amazon, Leksus LX470
+ Identification numbers of the car
+ Controls and receptions of safe operation of the car
+ Options and car routine maintenance
+ The engine
+ Systems of cooling of the engine, salon and air conditioning heating
+ The power supply system and release of the fulfilled gases
+ Engine electric equipment
+ Control systems of the engine and decrease in toxicity of the fulfilled gases
+ Gear change box
- Transmissionnaja line
   Specifications
   Kardannye shaft and hinges - the general information
   Condition check трансмиссионной lines
   Removal and installation карданного a shaft
   Replacement карданных hinges
   Privodnye shaft/semiaxes, - the general information and condition check
   Removal and installation of semiaxes, bearings and epiploons of the back bridge
   Replacement of an epiploon of a leading gear wheel of differential
   Removal and installation of assemblage of the back bridge
   Removal and installation of power shafts
   Replacement of protective covers and service of SHRUS
   Removal and installation of assemblage of forward differential
   Removal and installation of naves from a disconnected drive
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment





Transmissionnaja line

The present Chapter is devoted трансмиссионным to the components located between a back part of the engine and wheels of the car (without a transmission and a distributing box which are considered in the Head a gear change Box). According to the destination considered components can be broken on two categories: карданные shaft and semiaxes/power shafts. In below-mentioned Sections descriptions of a design and a principle of action of each of separate knots, and also procedures of check of a condition, removal and dismantling of the components entering into both groups are resulted.

As the most part of procedures described in the present Chapter is made under the car, it is necessary to give special attention to reliability of fixing of the last in the lifted position.