Tojota Lend Kruzer, Amazon, Leksus LX470
+ Identification numbers of the car
+ Controls and receptions of safe operation of the car
+ Options and car routine maintenance
+ The engine
+ Systems of cooling of the engine, salon and air conditioning heating
+ The power supply system and release of the fulfilled gases
+ Engine electric equipment
+ Control systems of the engine and decrease in toxicity of the fulfilled gases
+ Gear change box
- Transmissionnaja line
Specifications
Kardannye shaft and hinges - the general information
Condition check трансмиссионной lines
Removal and installation карданного a shaft
Replacement карданных hinges
Privodnye shaft/semiaxes, - the general information and condition check
Removal and installation of semiaxes, bearings and epiploons of the back bridge
Replacement of an epiploon of a leading gear wheel of differential
Removal and installation of assemblage of the back bridge
Removal and installation of power shafts
Replacement of protective covers and service of SHRUS
Removal and installation of assemblage of forward differential
Removal and installation of naves from a disconnected drive
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
|
Removal and installation of power shafts
Nave of a forward suspension bracket
|
|
1. Ослабьте wheel nuts, поддомкратьте the car also establish it on props. Remove a corresponding forward wheel.
2. Empty differential (see the Head of Adjustment and car routine maintenance).
3. Remove a brake support (the Brake system see the Head).
4. Remove a nave (see Has undressed Removal and installation of naves from a disconnected drive), then take a lock ring and throw off a remote washer (address to an illustration above).
5. Обстучав through brass выколотку, ослабьте shaft landing in assemblage of a rotary fist.
6. Disconnect from a rotary fist the bottom lever of a suspension bracket (the Suspension bracket and a steering see the Head).
7. Take away fist assemblage outside and liberate an internal pin of a power shaft from differential assemblage, – in case of need обстучите a shaft a hammer with soft brisk for easing of its landing in a lateral gear wheel.
8. Installation is made upside-down. Track reliability of a tightening ступичной nuts. |
|
|
|