Tojota Lend Kruzer, Amazon, Leksus LX470
+ Identification numbers of the car
+ Controls and receptions of safe operation of the car
+ Options and car routine maintenance
+ The engine
+ Systems of cooling of the engine, salon and air conditioning heating
+ The power supply system and release of the fulfilled gases
+ Engine electric equipment
+ Control systems of the engine and decrease in toxicity of the fulfilled gases
+ Gear change box
- Transmissionnaja line
Specifications
Kardannye shaft and hinges - the general information
Condition check трансмиссионной lines
Removal and installation карданного a shaft
Replacement карданных hinges
Privodnye shaft/semiaxes, - the general information and condition check
Removal and installation of semiaxes, bearings and epiploons of the back bridge
Replacement of an epiploon of a leading gear wheel of differential
Removal and installation of assemblage of the back bridge
Removal and installation of power shafts
Replacement of protective covers and service of SHRUS
Removal and installation of assemblage of forward differential
Removal and installation of naves from a disconnected drive
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
|
Removal and installation of semiaxes, bearings and epiploons of the back bridge
Details of installation of a back semiaxis and nave
|
|
1. Release a lay brake. Поддомкратьте a back of the car also establish it on props. Prop up forward wheels противооткатными boots. Details of installation of a semiaxis are presented on an illustration above.
2. On equipped ABS models remove the wheel gauge. (The Brake system) see the Head.
3. Remove assemblage of the brake mechanism (the Brake system see the Head).
4. Disconnect a cable of a drive of a lay brake and a hydraulic line from the wheel cylinder (the Brake system see the Head).
5. Give four nuts of fastening of a back plate of a semiaxis to картеру the back bridge.
6. Take полуось from картера the bridge, try not to damage an epiploon.
7. Take from the flute in a face surface картера a sealing ring.
|
|
8. Having hooked the big screw-driver, or having taken advantage of the special tool, take a semiaxis epiploon (address to an accompanying illustration). |
9. The further dismantling of the back bridge demands use of special tools, including a hydraulic press and should be charged experts of car-care centre.
10. Having taken advantage in quality оправки of a face head of the suitable size or a piece of a pipe of the corresponding diameter, plant in картер the bridge a new epiploon of a semiaxis, grease sponges of an epiploon with universal greasing.
11. Slightly having oiled, establish a new sealing ring.
12. Estimate a condition of a surface of a semiaxis, remove teases and the agnails, capable to lead to epiploon damage. Slightly grease полуось with pure oil and fill it in картер the bridge, try not to damage шлицами an epiploon.
13. The further installation is made as it should be the return to an order of dismantle of components. Track, that nuts of fastening of a face plate have been tightened with demanded effort. |
|
|
|