Toyota Land Cruiser 100 / Amazon, Lexus LX 470

Since 1997 of release

Repair and car operation

Tojota Lend Kruzer, Amazon, Leksus LX470
+ Identification numbers of the car
+ Controls and receptions of safe operation of the car
+ Options and car routine maintenance
+ The engine
+ Systems of cooling of the engine, salon and air conditioning heating
+ The power supply system and release of the fulfilled gases
+ Engine electric equipment
+ Control systems of the engine and decrease in toxicity of the fulfilled gases
+ Gear change box
- Transmissionnaja line
   Kardannye shaft and hinges - the general information
   Condition check трансмиссионной lines
   Removal and installation карданного a shaft
   Replacement карданных hinges
   Privodnye shaft/semiaxes, - the general information and condition check
   Removal and installation of semiaxes, bearings and epiploons of the back bridge
   Replacement of an epiploon of a leading gear wheel of differential
   Removal and installation of assemblage of the back bridge
   Removal and installation of power shafts
   Replacement of protective covers and service of SHRUS
   Removal and installation of assemblage of forward differential
   Removal and installation of naves from a disconnected drive
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment

Condition check трансмиссионной lines


1. Поддомкратьте a back of the car also establish it on props, prop up forward wheels противооткатными boots.
2. Having got under the car, visually estimate a condition карданного a shaft. In case of revealing of deformations and cracks replace a shaft.
3. Check up the forward and back ends of a shaft on presence of signs of development of leaks. In case of need make replacement of a corresponding epiploon (ов) (the Section Replacement of an epiploon of a leading gear wheel of differential see).
4. Without getting out from under the car, ask the assistant повращать car wheels, having caused thereby rotation карданного a shaft, hinges should be turned freely and silently. Estimate a condition of a rubber element of assemblage of the central bearing, replace defective components.
5. The condition карданных hinges can be checked up and at a motionless shaft, urgently grasp each of sections of the hinge and try повращать them from each other, presence a little appreciable люфта testifies to deterioration of internal components шарнирной assemblages.
6. Estimate reliability of a tightening of fixing bolts of a connecting flange.
7. Check up shaft on presence of leaks through epiploons sliding муфт.
8. Taking an opportunity check up also on presence of signs of leaks приводные shaft/semiaxes. Estimate a condition of protective covers of hinges of equal angular speeds. In case of need make replacement of epiploons of differential.