Toyota Land Cruiser 100 / Amazon, Lexus LX 470

Since 1997 of release

Repair and car operation

Tojota Lend Kruzer, Amazon, Leksus LX470
+ Identification numbers of the car
+ Controls and receptions of safe operation of the car
+ Options and car routine maintenance
+ The engine
+ Systems of cooling of the engine, salon and air conditioning heating
+ The power supply system and release of the fulfilled gases
+ Engine electric equipment
+ Control systems of the engine and decrease in toxicity of the fulfilled gases
+ Gear change box
- Transmissionnaja line
   Specifications
   Kardannye shaft and hinges - the general information
   Condition check трансмиссионной lines
   Removal and installation карданного a shaft
   Replacement карданных hinges
   Privodnye shaft/semiaxes, - the general information and condition check
   Removal and installation of semiaxes, bearings and epiploons of the back bridge
   Replacement of an epiploon of a leading gear wheel of differential
   Removal and installation of assemblage of the back bridge
   Removal and installation of power shafts
   Replacement of protective covers and service of SHRUS
   Removal and installation of assemblage of forward differential
   Removal and installation of naves from a disconnected drive
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment

Removal and installation of naves from a disconnected drive

Details of installation of a nave with manual switching-off of a drive of forward wheels


1 — the Conic washer 2 — the Nut 3 — the Sealing lining 4 — the nave Case	5 — the Bolt 6 — the Sealing lining 7 — a nave Cover

Components of the lock of a nave with manual switching-off of a drive


1 — the Lock ring 2 — the Remote ring 3 — the nave Case 4 — the Lock ring 5 — the Gear ring of a nave 6 — the Internal nave 7 — Mufta of coupling of the lock of a nave	8 — Drove 9 — the Lock ring 10 — the Steel ball with a spring 11 — a nave Cover 12 — the Spring 13 — the Spring 14 — the Handle of management with an epiploon

PERFORMANCE ORDER

1. Translate a nave cover in position Free (Freely).
2. Turn out fixing bolts, then uncover also internal components of a nave (address to an illustration of the Detail of installation of a nave with manual switching-off of a drive of forward wheels).
3. At a corresponding complete set turn out a bolt from a power shaft end face.
4. Give nuts of fastening of the case of a nave.
5. By means of brass выколотки bring down from assemblage конусные washers.
6. Remove the case of a nave with equipped шлицами power shaft pins.
7. Refusal of locks of inclusion of a drive of naves occurs owing to hit in them a dirt and a moisture more often. If there is a necessity for the further dismantling of a nave, try to pay the most steadfast attention to an order and a way of installation of each of components. Put components on a workbench as their dismantle. Serially wipe each of details, grease components with universal greasing, then establish them on the regular places (address to an illustration Components of the lock of a nave with manual switching-off of a drive).
8. Installation of components of a nave is made as it should be the return to an order of their dismantle. Do not forget to replace sealing linings and to grease шлицы the internal loose leaf with universal greasing. Before installation the management handle on a nave cover should be turned in position Free, track correctness of input in gearing of uvulas drove with the sites of the case of assemblage deprived of teeths.