Tojota Lend Kruzer, Amazon, Leksus LX470
+ Identification numbers of the car
+ Controls and receptions of safe operation of the car
+ Options and car routine maintenance
+ The engine
+ Systems of cooling of the engine, salon and air conditioning heating
+ The power supply system and release of the fulfilled gases
+ Engine electric equipment
+ Control systems of the engine and decrease in toxicity of the fulfilled gases
+ Gear change box
- Transmissionnaja line
Specifications
Kardannye shaft and hinges - the general information
Condition check трансмиссионной lines
Removal and installation карданного a shaft
Replacement карданных hinges
Privodnye shaft/semiaxes, - the general information and condition check
Removal and installation of semiaxes, bearings and epiploons of the back bridge
Replacement of an epiploon of a leading gear wheel of differential
Removal and installation of assemblage of the back bridge
Removal and installation of power shafts
Replacement of protective covers and service of SHRUS
Removal and installation of assemblage of forward differential
Removal and installation of naves from a disconnected drive
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
|
Removal and installation of assemblage of the back bridge
|
|
At a corresponding complete set block differential of the back bridge. |
|
|
1. Ослабьте nuts of fastening of back wheels. Поддомкратьте the car also establish it on the props got under bearing frame, not under the back bridge). Prop up forward wheels противооткатными boots. Remove back wheels.
2. Get a jack under картер differential of assemblage of the back bridge.
3. Disconnect карданный a shaft from differential (see Has undressed Removal and installation карданного a shaft) and tie up it aside to frame elements. Remove semiaxes (see Has undressed Removal and installation of semiaxes, bearings and epiploons of the back bridge).
4. Disconnect from картера the bridge all brake lines fixed on it. At once закупорьте the open ends of tubes and hoses.
5. Remove assemblages of back brake mechanisms (the Brake system see the Head).
6. Disconnect from brake mechanisms cables of a drive of a lay brake, then liberate cables from clamps on картере the back bridge (the Brake system see the Head).
7. Disconnect from картера the back bridge and tie up aside a ventilating hose.
8. Remove shock-absorbers from basic arms on картере the bridge, compress them and take aside.
9. Disconnect a bar of the stabilizer of cross-section stability, a cross-section jet bar, the top and bottom levers of a suspension bracket (the Suspension bracket and a steering see the Head).
10. Lower the jack got under differential and take assemblage of the back bridge from under the car.
11. Installation is made upside-down. Track, that all fixture of elements of a suspension bracket has been tightened with demanded effort (the Suspension bracket and a steering see the Head).
12. Pump over brake system (the Brake system see the Head). |
|
|
|