Toyota Land Cruiser 100 / Amazon, Lexus LX 470

Since 1997 of release

Repair and car operation

Tojota Lend Kruzer, Amazon, Leksus LX470
+ Identification numbers of the car
+ Controls and receptions of safe operation of the car
+ Options and car routine maintenance
- The engine
   + Typical procedures of service of engines
   + Procedures of service of the petrol engine
   - Procedures of service of the diesel engine
      Removal, installation, dismantling and assemblage of a head of cylinders
      Removal and installation of the inlet pipeline and final collector
      Removal, check of a condition and installation of a belt of drive ГРМ
      Removal and installation of cogwheels of drive ГРМ
      Replacement of a forward epiploon of a cranked shaft and epiploons of a camshaft and ТНВД
      Replacement of a back epiploon of a cranked shaft
      Removal and installation of camshafts and pushers of valves
      Removal and pallet installation картера the engine
      Removal, check of a condition and installation of the oil pump
      Removal and installation маслоохладителя
      Removal and installation приводного a disk
+ Systems of cooling of the engine, salon and air conditioning heating
+ The power supply system and release of the fulfilled gases
+ Engine electric equipment
+ Control systems of the engine and decrease in toxicity of the fulfilled gases
+ Gear change box
+ Transmissionnaja line
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment

Procedures of service of the diesel engine

The general information

Рядный the 6-cylinder diesel engine 1HD-FTE in volume 4.2 l. The Head of cylinders is established on cars Toyota Land Cruiser since 1997 equipped by two distributive shaft of the top arrangement (design DOHC). On each of cylinders it is necessary on four valves (2 inlet and two final), – only 24 valves.

Descriptions большей parts of considered procedures are made on the basis of the assumption that the power unit remains on the regular place in an impellent compartment of the car. In view of told, in a case if the engine is already dismantled and established on a workbench or the assembly stand, many of described steps should be lowered.