Toyota Land Cruiser 100 / Amazon, Lexus LX 470

Since 1997 of release

Repair and car operation

Tojota Lend Kruzer, Amazon, Leksus LX470
+ Identification numbers of the car
+ Controls and receptions of safe operation of the car
+ Options and car routine maintenance
- The engine
   + Typical procedures of service of engines
   + Procedures of service of the petrol engine
   - Procedures of service of the diesel engine
      Removal, installation, dismantling and assemblage of a head of cylinders
      Removal and installation of the inlet pipeline and final collector
      Removal, check of a condition and installation of a belt of drive ГРМ
      Removal and installation of cogwheels of drive ГРМ
      Replacement of a forward epiploon of a cranked shaft and epiploons of a camshaft and ТНВД
      Replacement of a back epiploon of a cranked shaft
      Removal and installation of camshafts and pushers of valves
      Removal and pallet installation картера the engine
      Removal, check of a condition and installation of the oil pump
      Removal and installation маслоохладителя
      Removal and installation приводного a disk
+ Systems of cooling of the engine, salon and air conditioning heating
+ The power supply system and release of the fulfilled gases
+ Engine electric equipment
+ Control systems of the engine and decrease in toxicity of the fulfilled gases
+ Gear change box
+ Transmissionnaja line
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment

Replacement of a back epiploon of a cranked shaft

PERFORMANCE ORDER

1. Remove АТ or a coupling basket (the gear change Box see the Head).
2. Remove приводной a disk or a flywheel.

3. Remove a back plate of the engine (address to an accompanying illustration).

4. Removal of an old epiploon can be made without preliminary dismantle of its case by поддевания its screw-driver, however, in order to avoid risk of damage of a pin of a cranked shaft, composers of the present Management recommend to operate according to the instructions stated more low.

5. Turn out bolts of fastening of the case of an epiploon to the block and remove assemblage, smooth out interfaced surfaces from fragments of a material of a lining and old hermetic (address to an accompanying illustration).

6. Having laid the removed holder on a workbench on two wooden blocks, beat out an old epiploon выколоткой from the back party of a plate (address to an illustration).

7. Wipe a nest under landing of an epiploon by acetone. Lay the holder on a flat firm surface and begin to knock in a nest a new epiploon, in quality оправки having taken advantage wooden бруском or a piece of a pipe of suitable diameter.
8. Grease epiploon sponges with pure impellent oil.

9. Accurately having pressed the holder, plant it on the regular place. Operate without hurrying up, watching that has not occurred заворачивания epiploon sponges at its putting on on a shaft pin (address to an illustration). Screw fixing bolts and in regular intervals tighten them with demanded effort.

10. The further installation is made in an order, the return to an order of dismantle of components.