Toyota Land Cruiser 100 / Amazon, Lexus LX 470

Since 1997 of release

Repair and car operation

Tojota Lend Kruzer, Amazon, Leksus LX470
+ Identification numbers of the car
+ Controls and receptions of safe operation of the car
+ Options and car routine maintenance
- The engine
   + Typical procedures of service of engines
   + Procedures of service of the petrol engine
   - Procedures of service of the diesel engine
      Removal, installation, dismantling and assemblage of a head of cylinders
      Removal and installation of the inlet pipeline and final collector
      Removal, check of a condition and installation of a belt of drive ГРМ
      Removal and installation of cogwheels of drive ГРМ
      Replacement of a forward epiploon of a cranked shaft and epiploons of a camshaft and ТНВД
      Replacement of a back epiploon of a cranked shaft
      Removal and installation of camshafts and pushers of valves
      Removal and pallet installation картера the engine
      Removal, check of a condition and installation of the oil pump
      Removal and installation маслоохладителя
      Removal and installation приводного a disk
+ Systems of cooling of the engine, salon and air conditioning heating
+ The power supply system and release of the fulfilled gases
+ Engine electric equipment
+ Control systems of the engine and decrease in toxicity of the fulfilled gases
+ Gear change box
+ Transmissionnaja line
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment

Removal and installation маслоохладителя

Assemblage components маслоохладителя are presented on an accompanying illustration.

Installation components маслоохладителя

1 — the Cover маслоохладителя
2, 4, 6 — the Lining
3 — the Return valve
5 — Masloohladitel
7 — ShChup
8 — the Filter
9 — the Tube щупа

10 — tube Consolidation
11 — the Stopper
12 — the Washer
13 — the Spring
14 — the Safety valve
15 — the safety valve Case
16 — the Drain stopper


1. Merge ОЖ and remove the oil filter
2. Remove a gear belt and cogwheel ТНВД.
3. Remove ТНВД.
4. Take out щуп and remove its directing.
5. Give fixture and remove assemblage маслоохладителя.
6. If necessary turn out gauge ECT.
7. Give 4 nuts and separate a cover from маслоохладителя.
8. Remove safety and return valves.
9. Installation is made upside-down. Tighten fixture with demanded effort.