Tojota Lend Kruzer, Amazon, Leksus LX470
+ Identification numbers of the car
+ Controls and receptions of safe operation of the car
+ Options and car routine maintenance
- The engine
+ Typical procedures of service of engines
+ Procedures of service of the petrol engine
- Procedures of service of the diesel engine
Removal, installation, dismantling and assemblage of a head of cylinders
Removal and installation of the inlet pipeline and final collector
Removal, check of a condition and installation of a belt of drive ГРМ
Removal and installation of cogwheels of drive ГРМ
Replacement of a forward epiploon of a cranked shaft and epiploons of a camshaft and ТНВД
Replacement of a back epiploon of a cranked shaft
Removal and installation of camshafts and pushers of valves
Removal and pallet installation картера the engine
Removal, check of a condition and installation of the oil pump
Removal and installation маслоохладителя
Removal and installation приводного a disk
+ Systems of cooling of the engine, salon and air conditioning heating
+ The power supply system and release of the fulfilled gases
+ Engine electric equipment
+ Control systems of the engine and decrease in toxicity of the fulfilled gases
+ Gear change box
+ Transmissionnaja line
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
|
Removal and pallet installation картера the engine
Details of installation of the pallet картера and the oil pump
Removal
|
|
|
1. Elements of installation of the pallet картера the engine and the oil pump are shown on an illustration above.
2. Remove details of drive ГРМ (see Has undressed Removal and installation of cogwheels of drive ГРМ).
3. Merge cooling liquid.
4. Merge impellent oil and remove the oil filter.
5. Give pallet fixture картера then separate it from the engine block, in case of need accurately having hooked its small screw-driver or шпателем, try not to damage interfaced surfaces.
6. If necessary remove маслозаборник with a lining.
|
|
Installation
|
|
1. Accurately scratch out from interfaced surfaces of the pallet and the block all traces of hermetic and a material of an old lining. Carefully wipe interfaced surfaces the rags moistened in acetone. Clean a carving deaf болтовых apertures in aluminium moulding of the block.
2. Check up a condition of the mesh filter маслозаборника, wash out solvent маслозаборную a tube, replace a sealing lining, establish assemblage маслозаборника on the engine and with demanded effort tighten fixing bolts.
3. If removed, establish into place маслозаборник with a new lining, tightening bolts of its fastening with demanded effort.
|
|
4. Impose on the specified surfaces the platen of hermetic in the thickness 2 – 3 mm (address to an accompanying illustration). |
5. Accurately press the pallet to the block of the engine and screw fixing bolts. Moving from the centre outside, in three-four receptions tighten fixture with demanded efforts.
6. The further installation is made in an order, the return to an order of dismantle of components. Tighten fixture with demanded effort. Do not forget to replace the filter and to add oil.
7. Start the engine and check up the pallet on presence of signs of development of leaks. Check up also pressure of oil. |
|
|
|