Tojota Lend Kruzer, Amazon, Leksus LX470
+ Identification numbers of the car
+ Controls and receptions of safe operation of the car
+ Options and car routine maintenance
+ The engine
+ Systems of cooling of the engine, salon and air conditioning heating
+ The power supply system and release of the fulfilled gases
+ Engine electric equipment
+ Control systems of the engine and decrease in toxicity of the fulfilled gases
- Gear change box
- Automatic transmission (АТ)
Problem diagnostics АТ - the general information
Adjustment of draught of a gear change
Check, adjustment and replacement of the gauge-switch of the permission of start
Removal and installation of assemblage of the lever of selector AT
Removal and installation of automatic transmission
+ Distributing box
+ Transmissionnaja line
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
|
Adjustment of draught of a gear change
|
|
1. Check up freedom of moving of the executive lever while translating draughts of switching from position «Р» in all other positions of transmission, – if the indication of the indicator of the selector does not coincide with actually chosen position, it is necessary to make adjustment приводной draughts.
2. Поддомкратьте the car also establish it on props.
|
|
3. Ослабьте a nut of fastening of draught of switching to the selector lever (address to an accompanying illustration). |
4. Wring out the manual lever on transmission (the small lever connecting draught of switching with manual shaft in transmission) to the right against the stop, then return it on two clicks back, having translated that in АТ neutral position.
5. Translate the selector lever in car salon in position «N».
6. Ask the assistant to fix the selector lever in position «N» and from below tighten with demanded effort a fastening nut to it draughts of switching.
7. Make adjustment of the gauge-switch of the permission of start (the Section Check, adjustment and replacement of the gauge-switch of the permission of start see).
8. Make sure of correctness of adjustment: the selector lever should freely is translated in each of provided by a design of the device of positions, thus engine start should become possible only in positions «Р» and «N» the lever. In case of need repeat adjustment, achieving performance of all listed above conditions. |
|
|
|