Toyota Land Cruiser 100 / Amazon, Lexus LX 470

Since 1997 of release

Repair and car operation

Tojota Lend Kruzer, Amazon, Leksus LX470
+ Identification numbers of the car
+ Controls and receptions of safe operation of the car
+ Options and car routine maintenance
+ The engine
+ Systems of cooling of the engine, salon and air conditioning heating
+ The power supply system and release of the fulfilled gases
- Engine electric equipment
   Start of the engine from the auxiliary power supply
   Removal and installation of the storage battery
   Check of a condition and replacement of wires of the battery
   Ignition system - the general information and safety measures (petrol models)
   Check of functioning of system of ignition
   Replacement of the coil of ignition
   Check and adjustment of installation of a corner of an advancing of ignition/injection of fuel of the petrol engine
   Replacement of the module of ignition
   Charge system - the general information and safety measures
   Check of a condition of system of a charge
   Removal and generator installation
   Check of a condition and replacement of components of the generator
   Start system - the general information and safety measures
   Check of serviceability of functioning of a starter and start chain
   Removal and starter installation
   Removal and installation of the traction relay
+ Control systems of the engine and decrease in toxicity of the fulfilled gases
+ Gear change box
+ Transmissionnaja line
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment

Removal and generator installation

Details of installation of the generator


1. Disconnect a negative wire from the battery.

If the stereosystem established on the car is equipped by a security code before to disconnect the battery make sure that have a correct combination for audiosystem input in action!

2. Merge cooling liquid.
3. Remove a belt of a drive of the generator.
4. Remove protection картера and a radiator.
5. Remove pump GUR pulley.
6. Mark brought to the generator electroconducting and tyres of grounding and disconnect them from assemblage.
7. Turn out adjusting and axial bolts, and also a lock nut from an adjusting lath of the generator (address to an illustration above).
8. At generator replacement take the block removed from the engine in shop, – replaceable should correspond in accuracy to it on a standard size, plugs should have identical marks, the size and an arrangement, beaten out on the case, or put on шильду identification marks should coincide.
9. The New/restored generators can be delivered on the market without приводного a pulley, – in that case last should be rearranged from old assemblage.
10. Installation is made upside-down.
11. In summary adjust effort of a tension приводного a belt (see the Head of Adjustment and car routine maintenance) and check up pressure of a charge (the Section Check of a condition of system of a charge see).