Toyota Land Cruiser 100 / Amazon, Lexus LX 470

Since 1997 of release

Repair and car operation

Tojota Lend Kruzer, Amazon, Leksus LX470
+ Identification numbers of the car
+ Controls and receptions of safe operation of the car
+ Options and car routine maintenance
+ The engine
+ Systems of cooling of the engine, salon and air conditioning heating
+ The power supply system and release of the fulfilled gases
- Engine electric equipment
   Specifications
   Start of the engine from the auxiliary power supply
   Removal and installation of the storage battery
   Check of a condition and replacement of wires of the battery
   Ignition system - the general information and safety measures (petrol models)
   Check of functioning of system of ignition
   Replacement of the coil of ignition
   Check and adjustment of installation of a corner of an advancing of ignition/injection of fuel of the petrol engine
   Replacement of the module of ignition
   Charge system - the general information and safety measures
   Check of a condition of system of a charge
   Removal and generator installation
   Check of a condition and replacement of components of the generator
   Start system - the general information and safety measures
   Check of serviceability of functioning of a starter and start chain
   Removal and starter installation
   Removal and installation of the traction relay
+ Control systems of the engine and decrease in toxicity of the fulfilled gases
+ Gear change box
+ Transmissionnaja line
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment

Start system – the general information and safety measures

The system provides проворачивание the engine for the purpose of realisation of its start. The basic components of system are a starter with the traction relay established on it (the electromagnetic actuator), the storage battery, the lock of ignition and connecting electroconducting.

Design and components of installation of a starter on engines 2UZ-FE


1 — the Back bearing 2 — the Anchor 3 — the Forward bearing 4 — Assemblage of the electromagnetic actuator 5 — the Bearing 6 — an idling Gear wheel 7 — Assemblage of a forward cover 8 — Pylnik 9 — the Sealing ring 10 — Assemblage обгонной муфты 11 — the Steel ball	12 — the Returnable spring 13 — ShChetkoderzhatel 14, 15 — the Sealing ring 16 — the Winding статора 17 — the Back cover 18 — Pylnik 19 — conducting Protection 20 — Sealing rings 21 — the Starter 22 — the Socket

On engines 2UZ-FE assemblage of a starter with the traction relay (address to an illustration above) is established under inlet collectors between heads of cylinders.

At поворачивании the ignition key in position START the contour of management of system of start carries out food giving on the traction relay of a starter which makes switching of a food of the battery directly on the starter electromotor. The motor starts to rotate, simultaneously turning for a gear wreath of a flywheel/privodnogo of a disk a cranked shaft of the engine.

In a chain of management starter functioning includes the gauge-switch of the permission of the start, preventing possibility of start of the engine in the positions of transmission which are distinct from «Р» and «N».

At performance of any works on service of components of system of start it is necessary to observe following special safety measures:

Remember that excessively long проворачивание the engine a starter can lead to serious damages of the electromotor of the last as a result of an overheat. Never use a starter continuously долее 15 seconds then it should to allow cool down within one-two minutes;
Do not forget that the starter is connected directly to the battery that at casual handling, as a result of overloads and short circuits, does probable possibility дугообразования, fraught in turn by conducting ignition;
Performing any works with components of system of start, without fail disconnect a negative wire from the battery, remember that if the stereosystem established on the car is equipped by a security code before to disconnect the battery it is necessary to make sure of knowledge of a correct combination for audiosystem input in action!