Toyota Land Cruiser 100 / Amazon, Lexus LX 470

Since 1997 of release

Repair and car operation



Tojota Lend Kruzer, Amazon, Leksus LX470
+ Identification numbers of the car
+ Controls and receptions of safe operation of the car
+ Options and car routine maintenance
+ The engine
+ Systems of cooling of the engine, salon and air conditioning heating
+ The power supply system and release of the fulfilled gases
- Engine electric equipment
   Specifications
   Start of the engine from the auxiliary power supply
   Removal and installation of the storage battery
   Check of a condition and replacement of wires of the battery
   Ignition system - the general information and safety measures (petrol models)
   Check of functioning of system of ignition
   Replacement of the coil of ignition
   Check and adjustment of installation of a corner of an advancing of ignition/injection of fuel of the petrol engine
   Replacement of the module of ignition
   Charge system - the general information and safety measures
   Check of a condition of system of a charge
   Removal and generator installation
   Check of a condition and replacement of components of the generator
   Start system - the general information and safety measures
   Check of serviceability of functioning of a starter and start chain
   Removal and starter installation
   Removal and installation of the traction relay
+ Control systems of the engine and decrease in toxicity of the fulfilled gases
+ Gear change box
+ Transmissionnaja line
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment


Выгодное предложение: альбом юбилейные и памятные монеты россии в Москве.



Removal and installation of the traction relay

 PERFORMANCE ORDER

1. Remove a starter (see Has undressed Removal and starter installation).
2. Чертилкой or a paint mark position of a casing of the electromotor of a starter rather редукторной sections (address to an accompanying illustration).
3. Disconnect the tyre connecting a starter with the traction relay.
4. Turn out fastening screws редукторной sections стартерной assemblages to the electromagnetic actuator (address to an accompanying illustration).
5. Turn out through bolts of fastening to each other редукторной and motor sections of a starter (address to an accompanying illustration).
6. Separate motor section of assemblage from редукторной, then remove from last the traction relay.