Toyota Land Cruiser 100 / Amazon, Lexus LX 470

Since 1997 of release

Repair and car operation

Safety locks – the general information

Various combinations of safety locks, fusible inserts and chain breakers are applied to protection of contact chains of an electric equipment of the car. Assembly blocks, are established in salon of the car and in an impellent compartment of a vehicle (address to illustrations more low).

Arrangement of electric elements in a forward part of salon

Arrangement of electric elements of salon

Arrangement of electric elements of an impellent compartment

Each separate safety lock is used for protection of any concrete electric contour or at once several contours. The identification card of placing of safety locks in the assembly block is usually glued to a cover of the last, from its internal party.

In assembly blocks the safety locks of a compact design equipped with bayonet contact plugs, and if necessary easily taken by fingers from the nests in the block are located. At refusal any of electric power consumers first of all always it is necessary to check a condition of a corresponding safety lock. Turn a key in the ignition lock in position ON and by means of a lamp-sampler probe open plugs of each of safety locks. If the lamp lights up at connection to each of plugs, hence, a safety lock as it should be. If pressure takes place only from outside food givings, means, the safety lock has fused. We will notice also that usually the safety lock case is made of transparent plastic through which it is easy to define a condition of a working crosspiece (address to an accompanying illustration).

At replacement of the fused safety lock strictly watch that the established replaceable corresponded on type left of an element. The safety locks calculated on a various nominal current strength physically can differ nothing from each other, without being thus interchangeable. Each of electric chains has various working parametres and replacement of the safety lock calculated on a certain current strength requires various degree of protection, therefore, not corresponding to it on parametres is fraught with the most serious consequences (up to fire occurrence). Working parametres of a safety lock (a nominal current strength) are usually designated on its plastic case.

If the new safety lock after installation also fails at once, it is not meaningful to make its further replacement, before it is necessary to reveal and eliminate the reason of occurrence of an overload in a chain. In most cases that appears the short circuit of connecting electroconducting caused by damage of its isolation.