Removal and installation of a combination of devices
Screws of fastening of a combination of devices
|
1. Disconnect negative from the battery both wires (at first negative). 2. Remove a steering wheel (the Suspension bracket and a steering see the Head). 3. Remove the central section of furnish of the panel of devices (the Body see the Head). 4. Turn out fixing screws (address to an illustration above), take a combination of devices from the landing nest and disconnect electroconducting. 5. Remove protective glass. 6. Having removed cartridges of lamps and having turned out screws of fastening of the printed-circuit board, remove last from the back party of a combination of devices. 7. Turn out screws of fastening of devices and remove devices. 8. Installation is made upside-down. Do not forget that the negative wire is always connected to the battery in last turn. |
|
|