Check of serviceability of functioning and replacement of the breaker of indexes of turns/alarm systems and the switch of last
|
|
Models of cars considered in the present Management are equipped by system of additional safety (SRS). Before to start performance of any works near to the block of a pillow of safety, a steering column or the instrument panel, disconnect SRS in order to avoid reception of traumas at its casual operation (the Section of the Pillow of safety - the general information see). Electroconducting of chain SRS is easy for distinguishing on yellow colour of isolation.
|
|
|
If the stereosystem established on the car is equipped by a security code before to disconnect the battery make sure that have a correct combination for audiosystem input in action!
|
Check
Site of the breaker of indexes of turns/alarm systems
The breaker of indexes of turns/alarm systems is fixed under the left bottom section of furnish of the panel of devices (address to an illustration above).
Serviceability of functioning of the breaker proves to be true distinctly heard rhythmical clicking. At refusal of one of indexes frequency of operation of the breaker doubles, informing the driver on necessity of performance of replacement failed lamps/lamps.
|
|
| Simultaneous refusal of both indexes with high degree of probability testifies to failure of a corresponding safety lock in the internal assembly block. Refusal possibility actually the breaker, or подрулевого the switch is not excluded also. Check up a condition of contact connections of electroconducting of a corresponding chain. At выбивании a safety lock check up electroconducting on presence of signs of short circuit, be verified with schemes of electric connections (the Section of the Scheme of electric connections - the general information see). |
|
Replacement
The breaker
|
|
1. Remove the left bottom section of furnish of the panel of devices (the Body see the Head) and disconnect from assemblage of the breaker electroconducting and take the breaker.
2. Track, that the replaceable breaker on the standard size corresponded failed.
3. Installation is made upside-down. |
|
The alarm system switch
|
|
| Having hooked, liberate assemblage of the switch from the panel of devices, disconnect from the switch electroconducting. |
|
|