Toyota Land Cruiser 100 / Amazon, Lexus LX 470

Since 1997 of release

Repair and car operation


Tojota Lend Kruzer, Amazon, Leksus LX470
+ Identification numbers of the car
+ Controls and receptions of safe operation of the car
+ Options and car routine maintenance
+ The engine
+ Systems of cooling of the engine, salon and air conditioning heating
- The power supply system and release of the fulfilled gases
   Specifications
   Sbrasyvanie pressure in the power supply system
   Check of serviceability of functioning of the fuel pump, measurement of pressure of fuel
   Check of a condition and replacement of fuel lines and them штуцерных connections
   Removal and installation of a fuel tank
   Cleaning and repair of a fuel tank - the general data
   Removal and installation of the fuel pump
   Replacement of the gauge of the expense of fuel
   Removal and installation of assemblage of an air cleaner
   Removal, installation and adjustment of a cable of an accelerator
   System of electronic injection of fuel (EFI) - the general information
   Check of serviceability of functioning of system of electronic injection
   Check of a condition and replacement of components of system of injection
   Release system - the general information
   Removal and installation of atomizers
+ Engine electric equipment
+ Control systems of the engine and decrease in toxicity of the fulfilled gases
+ Gear change box
+ Transmissionnaja line
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment





Removal, installation and adjustment of a cable of an accelerator

Adjustment of a hummock of a drive темпостата is made in a similar manner.

Removal

 PERFORMANCE ORDER

1. Disconnect a negative wire from the battery.

If the stereosystem established on the car is equipped by a security code before to disconnect the battery make sure that have a correct combination for audiosystem input in action!

2. Ослабьте a counternut of a carving tip of fastening of a cable to the lever of a drive throttle заслонки (see an accompanying illustration).
3. Having turned the lever, liberate from it a cable tip.
4. Disconnect a cable from a pedal of gas and turn out two screws of fastening of a cover тросовой assemblages to a partition of an impellent compartment.
5. Involve a cable in an impellent compartment.

Installation and adjustment

 PERFORMANCE ORDER

1. Installation is made upside-down, track reliability of landing in an aperture in a partition of the rubber plug through passage.
2. Squeeze out against the stop a pedal of gas and make sure of completeness of opening throttle заслонки.
3. If заслонка opens not up to the end, ослабьте counternuts, squeeze out a pedal and make corresponding adjustment of a cable.
4. Tighten counternuts, make sure that at отпускании pedals заслонка it is completely closed.