Tojota Lend Kruzer, Amazon, Leksus LX470
+ Identification numbers of the car
+ Controls and receptions of safe operation of the car
+ Options and car routine maintenance
+ The engine
+ Systems of cooling of the engine, salon and air conditioning heating
- The power supply system and release of the fulfilled gases
Specifications
Sbrasyvanie pressure in the power supply system
Check of serviceability of functioning of the fuel pump, measurement of pressure of fuel
Check of a condition and replacement of fuel lines and them штуцерных connections
Removal and installation of a fuel tank
Cleaning and repair of a fuel tank - the general data
Removal and installation of the fuel pump
Replacement of the gauge of the expense of fuel
Removal and installation of assemblage of an air cleaner
Removal, installation and adjustment of a cable of an accelerator
System of electronic injection of fuel (EFI) - the general information
Check of serviceability of functioning of system of electronic injection
Check of a condition and replacement of components of system of injection
Release system - the general information
Removal and installation of atomizers
+ Engine electric equipment
+ Control systems of the engine and decrease in toxicity of the fulfilled gases
+ Gear change box
+ Transmissionnaja line
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
|
Sbrasyvanie pressure in the power supply system
|
|
Remember that gasoline is extremely an inflammable liquid! At work with power supply system components observe all taken measures of fire safety. Do not smoke! Do not come nearer to a place of work with open fire or the redurable not protected by a lamp shade! Do not make system service in the premises equipped working on natural gas and heating devices equipped with a control torch (such as водогреи and dryers for clothes). Do not forget that gasoline is among cancerogenic substances, i.e. the substances promoting development of a cancer! Try not to suppose fuel hit on open sites of a body, use rubber protective gloves, at casual unforeseen contact to fuel carefully wash out hands warm water with soap. Immediately collect the spilt fuel and do not put the rags impregnated with PETROLEUM PRODUCTS near to sources of open fire. Remember that the power supply system equipped with injection of fuel of models constantly is under pressure. Before to start a detachment of fuel lines, dump residual pressure in system. At service of components of the power supply system put on goggles. Constantly hold near at hand the class fire extinguisher In! |
|
|
1. Pressure dump in the power supply system should be carried out before service of any of its components for the purpose of minimisation of risk of ignition of fuel and reception by the executor of traumas.
2. For dump of superfluous pressure in a fuel tank uncover a jellied mouth.
3. There are two ways of dump of pressure in the power supply system: disunite a contact socket of electroconducting of the fuel pump, or take the Relay of Disconnection of the Chain, – estimate what of actions can be made with smaller expenses of forces and time. The socket of electroconducting of the pump is directly on assemblage of a fuel tank (see Has undressed Removal and installation of the fuel pump).
4. Start the engine and wait its spontaneous останова, then turn the ignition key in position OFF.
5. For a guarantee of completeness of a discharge of system turn the engine some more time a starter. Disconnect a negative wire from the battery.
|
|
If the stereosystem established on the car is equipped by a security code before to disconnect the battery make sure that have a correct combination for audiosystem input in action! |
6. At undocking штуцерных connections follows обкладывать their paper towels for gathering of spilt fuel. |
|
|
|