Toyota Land Cruiser 100 / Amazon, Lexus LX 470

Since 1997 of release

Repair and car operation

Tojota Lend Kruzer, Amazon, Leksus LX470
+ Identification numbers of the car
+ Controls and receptions of safe operation of the car
+ Options and car routine maintenance
+ The engine
+ Systems of cooling of the engine, salon and air conditioning heating
- The power supply system and release of the fulfilled gases
   Sbrasyvanie pressure in the power supply system
   Check of serviceability of functioning of the fuel pump, measurement of pressure of fuel
   Check of a condition and replacement of fuel lines and them штуцерных connections
   Removal and installation of a fuel tank
   Cleaning and repair of a fuel tank - the general data
   Removal and installation of the fuel pump
   Replacement of the gauge of the expense of fuel
   Removal and installation of assemblage of an air cleaner
   Removal, installation and adjustment of a cable of an accelerator
   System of electronic injection of fuel (EFI) - the general information
   Check of serviceability of functioning of system of electronic injection
   Check of a condition and replacement of components of system of injection
   Release system - the general information
   Removal and installation of atomizers
+ Engine electric equipment
+ Control systems of the engine and decrease in toxicity of the fulfilled gases
+ Gear change box
+ Transmissionnaja line
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment

Removal and installation of a fuel tank

Preventions in pressure Razdela Sbrasyvanie beginning in the power supply system see.

Details of installation of a fuel tank


1. For the purpose of dump of superfluous pressure in a tank uncover a jellied mouth.
2. Disconnect a negative wire from the battery.

If the stereosystem established on the car is equipped by a security code before to disconnect the battery make sure that have a correct combination for audiosystem input in action!

3. Поддомкратьте the car also establish it on props.
4. Turn out a drain stopper and lower fuel in the prepared capacity of suitable volume (address to an illustration above).
5. Disconnect electroconducting of the fuel pump/gauge of the expense of fuel and remove them.
6. Remove the protective pallet of a fuel tank.
7. Disconnect gasoline pipe lines and a line of return of fuel evaporations.

Each of the mentioned lines has unique diameter that guarantees unambiguity of their connection at assemblage. In case of doubts mark disconnected components. At once закупорьте the open ends of tubes.

8. Turn out fixing screws and disconnect a jellied mouth and a ventilating tube of a fuel tank.
9. Prop up a tank тележечным a jack, for loading distribution having laid between a head of the last and a tank bottom wooden брусок.
10. Release fixture and lower assembly скобы tank fastenings then smoothly lower a tank downwards.
11. Installation is made upside-down. Track, that tubes and hoses have not been pressed.