Toyota Land Cruiser 100 / Amazon, Lexus LX 470

Since 1997 of release

Repair and car operation



Tojota Lend Kruzer, Amazon, Leksus LX470
+ Identification numbers of the car
+ Controls and receptions of safe operation of the car
+ Options and car routine maintenance
+ The engine
+ Systems of cooling of the engine, salon and air conditioning heating
- The power supply system and release of the fulfilled gases
   Specifications
   Sbrasyvanie pressure in the power supply system
   Check of serviceability of functioning of the fuel pump, measurement of pressure of fuel
   Check of a condition and replacement of fuel lines and them штуцерных connections
   Removal and installation of a fuel tank
   Cleaning and repair of a fuel tank - the general data
   Removal and installation of the fuel pump
   Replacement of the gauge of the expense of fuel
   Removal and installation of assemblage of an air cleaner
   Removal, installation and adjustment of a cable of an accelerator
   System of electronic injection of fuel (EFI) - the general information
   Check of serviceability of functioning of system of electronic injection
   Check of a condition and replacement of components of system of injection
   Release system - the general information
   Removal and installation of atomizers
+ Engine electric equipment
+ Control systems of the engine and decrease in toxicity of the fulfilled gases
+ Gear change box
+ Transmissionnaja line
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment





Removal and installation of atomizers

Details of installation of atomizers

1, 5 — the Vacuum hose (models with system EGR)
2 — the Returnable fuel tube of an atomizer №3
3, 26 — the Clip
4, 12 — the Vacuum hose
6 — the Returnable fuel tube of an atomizer №1
7, 11, 16, 18, 23, 25 — the Lining
8 — the Sealing washer
9 — the Cover of a head of cylinders
10, 27 — the Thermofilter
13 — the Inlet pipeline
14 — the Heater on an admission
15 — valve EGR Arm
17 — Assemblage of the inlet pipeline
19 — the Atomizer
20 — the Adapter
21 — the Sealing ring
22 — an atomizer Saddle

24 — Fuel tubes of a high pressure
28 — Assemblage of a drive throttle заслонки
29 — the Socket of the gauge of position of a pedal of gas
And — Without system EGR
B, With — system EGR
15 — valve EGR Arm
17 — Assemblage of the inlet pipeline
19 — the Atomizer
20 — the Adapter
21 — the Sealing ring
22 — an atomizer Saddle
24 — Fuel tubes of a high pressure
28 — Assemblage of a drive throttle заслонки
29 — the Socket of the gauge of position of a pedal of gas
And — Without system EGR
B, With — system EGR


 PERFORMANCE ORDER

1. Remove inlet парубок
2. Uncover heads of cylinders
3. Disconnect a socket of the gauge of position of a pedal of gas and remove assemblage of a drive throttle заслонки.
4. Remove a returnable fuel tube of an atomizer №1 and high pressure tubes.
5. Remove adapters between atomizers and tubes of a high pressure from a head of cylinders.
6. Turn out a bolt of fastening of a clip of an atomizer.
7. Take out an atomizer with a saddle from a head of cylinders.
8. Remove from an atomizer sealing rings
9. Installation is made upside-down. Tighten fixture with demanded effort.