Toyota Land Cruiser 100 / Amazon, Lexus LX 470

Since 1997 of release

Repair and car operation



Tojota Lend Kruzer, Amazon, Leksus LX470
+ Identification numbers of the car
+ Controls and receptions of safe operation of the car
+ Options and car routine maintenance
+ The engine
+ Systems of cooling of the engine, salon and air conditioning heating
- The power supply system and release of the fulfilled gases
   Specifications
   Sbrasyvanie pressure in the power supply system
   Check of serviceability of functioning of the fuel pump, measurement of pressure of fuel
   Check of a condition and replacement of fuel lines and them штуцерных connections
   Removal and installation of a fuel tank
   Cleaning and repair of a fuel tank - the general data
   Removal and installation of the fuel pump
   Replacement of the gauge of the expense of fuel
   Removal and installation of assemblage of an air cleaner
   Removal, installation and adjustment of a cable of an accelerator
   System of electronic injection of fuel (EFI) - the general information
   Check of serviceability of functioning of system of electronic injection
   Check of a condition and replacement of components of system of injection
   Release system - the general information
   Removal and installation of atomizers
+ Engine electric equipment
+ Control systems of the engine and decrease in toxicity of the fulfilled gases
+ Gear change box
+ Transmissionnaja line
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment





Removal and installation of the fuel pump

Preventions in pressure Razdela Sbrasyvanie beginning in the power supply system see.

The components which are subject to removal for access to the fuel pump

Details of installation of assemblage of the fuel pump/gauge of the expense of fuel

Removal

 PERFORMANCE ORDER

1. Dump pressure in the power supply system (Razdel Sbrasyvanie of pressure in the power supply system see).
2. Disconnect a negative wire from the battery.

If the stereosystem established on the car is equipped by a security code before to disconnect the battery make sure that have a correct combination for audiosystem input in action!

3. For access to the pump in salon, under a back rug, there is a demountable cover (address to an illustration above).
4. Remove back seats, having turned out their fixing bolts, preliminary having removed from them covers.
5. Remove a threshold overlay, a lateral overlay and a step overlay. Then remove carpet coverings.
6. Uncover technological лючка.
7. Disconnect from a pump arm fuel lines, preliminary having removed from them a dirt (address to an accompanying illustration).
8. Give eight screws and cautiously take assemblage of the pump with the gauge of the expense of fuel from a petrol tank (address to an accompanying illustration). The lining can be thrown out – for installation it is required new.

Try not to bend a leg of a float of the gauge.

9. Liberate the bottom section of pump assemblage from a basic arm (address to an illustration of the Detail of installation of assemblage of the fuel pump/gauge of the expense of fuel). Disconnect electroconducting from assemblage of the fuel pump/gauge of the expense of fuel and remove a fuel hose.
10. Remove rubber consolidation and a lock ring of fastening of the mesh filter топливозаборника.
11. Remove the mesh filter and estimate degree of its pollution, in case of need make replacement.

Installation

 PERFORMANCE ORDER

Installation is made upside-down. Do not forget to replace a sealing lining of a landing flange, at a corresponding complete set replace both sealing washers of a hollow bolt штуцерного a socket. Tighten fixture with demanded effort.