Tojota Lend Kruzer, Amazon, Leksus LX470
+ Identification numbers of the car
+ Controls and receptions of safe operation of the car
+ Options and car routine maintenance
+ The engine
+ Systems of cooling of the engine, salon and air conditioning heating
- The power supply system and release of the fulfilled gases
Specifications
Sbrasyvanie pressure in the power supply system
Check of serviceability of functioning of the fuel pump, measurement of pressure of fuel
Check of a condition and replacement of fuel lines and them штуцерных connections
Removal and installation of a fuel tank
Cleaning and repair of a fuel tank - the general data
Removal and installation of the fuel pump
Replacement of the gauge of the expense of fuel
Removal and installation of assemblage of an air cleaner
Removal, installation and adjustment of a cable of an accelerator
System of electronic injection of fuel (EFI) - the general information
Check of serviceability of functioning of system of electronic injection
Check of a condition and replacement of components of system of injection
Release system - the general information
Removal and installation of atomizers
+ Engine electric equipment
+ Control systems of the engine and decrease in toxicity of the fulfilled gases
+ Gear change box
+ Transmissionnaja line
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
|
Release system – the general information
|
|
It is necessary to start service of system of release only after full cooling of its components, remember that the surface каталитического the converter while in service the car can heat up to very heats! Track reliability of fixing of the car in the lifted position.
|
Typical design of system of release of the fulfilled gases
Replacement of components of system of release of the fulfilled gases consists mainly in dismantle and installation of thermoprotective screens/detachments and connection of sections of assemblage (address to an illustration above). It is necessary to remember that thermofilters and rubber подвесы basic arms should be established at assemblage strictly on the former places. Whereas while in service the car components of system of release of the fulfilled gases constantly are exposed to aggressive influences of environment and heats, assemblage components can appear «tightly become attached» to each other, therefore, before to start to отпусканию fixture, it is necessary to impregnate joints of corresponding sections with getting oil. In especially hard cases it is necessary to take advantage ножовкой, a chisel or autogenous cutting.
|
|