Toyota Land Cruiser 100 / Amazon, Lexus LX 470

Since 1997 of release

Repair and car operation


Tojota Lend Kruzer, Amazon, Leksus LX470
+ Identification numbers of the car
+ Controls and receptions of safe operation of the car
+ Options and car routine maintenance
- The engine
   + Typical procedures of service of engines
   - Procedures of service of the petrol engine
      Removal and installation of covers of heads of cylinders
      Removal and installation of the inlet pipeline
      Removal and installation of final collectors
      Removal, check of a condition and installation газораспределительного a belt and cogwheels of drive ГРМ
      Replacement of a forward epiploon (ов) a cranked shaft / of camshafts
      Replacement of a back epiploon of a cranked shaft
      Removal and installation of camshafts and pushers of valves
      Removal and installation of heads of cylinders
      Removal and pallet installation картера the engine
      Removal, check of a condition and installation of the oil pump
      Removal and installation приводного a disk
      Check of a condition and replacement of support of an engine mount
   + Procedures of service of the diesel engine
+ Systems of cooling of the engine, salon and air conditioning heating
+ The power supply system and release of the fulfilled gases
+ Engine electric equipment
+ Control systems of the engine and decrease in toxicity of the fulfilled gases
+ Gear change box
+ Transmissionnaja line
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment





Check of a condition and replacement of support of an engine mount

Support of a suspension bracket of the power unit extremely seldom require the attention, however the damaged pillows should be replaced without any delay in order to avoid increase of loadings and premature deterioration of components трансмиссионной lines.

Check

 PERFORMANCE ORDER

1. For check it is necessary to raise slightly the engine, having unloaded support.
2. Поддомкратьте the car also establish it on props. Get a jack under the pallet картера the engine (for the purpose of loading distribution lay between a head of a jack and the pallet wooden брусок). Cock a jack, slightly having raised the unit and having unloaded support.

At all do not perform any works under the car, kept in the lifted position by means of only one jack!

3. Check up pillows of support (address to an accompanying illustration) on presence of cracks, signs of hardening of rubber and отслоения from the metal basis. Sometimes pillows start to break directly in the middle.
4. Estimate size люфта between plates of support and the power unit/frame of the car (as the lever take advantage of mount or the big screw-driver). In case of revealing люфта lower the unit and tighten fixture of support.
5. Pillows, in order to avoid rubber destruction, should be processed special protective structure.

Replacement

 PERFORMANCE ORDER

1. Disconnect a negative wire from the battery.

If the stereosystem established on the car is equipped by a security code before to disconnect the battery make sure that have a correct combination for audiosystem input in action!

Cock a lay brake, поддомкратьте redock of the car and establish it on props. Prop up the engine (paragraph 2, Check see).
2. Release fixture to subject replacement of a support, raise the engine and remove a pillow.
3. Installation is made upside-down.

Before installation it is necessary to grease a carving part of fixture of support with fixing hermetic. Track reliability of a tightening of fixture.

4. The description of procedures of replacement of support of a suspension bracket of transmission is resulted in the Head a gear change Box.