Toyota Land Cruiser 100 / Amazon, Lexus LX 470

Since 1997 of release

Repair and car operation

Tojota Lend Kruzer, Amazon, Leksus LX470
+ Identification numbers of the car
+ Controls and receptions of safe operation of the car
+ Options and car routine maintenance
- The engine
   + Typical procedures of service of engines
   - Procedures of service of the petrol engine
      Removal and installation of covers of heads of cylinders
      Removal and installation of the inlet pipeline
      Removal and installation of final collectors
      Removal, check of a condition and installation газораспределительного a belt and cogwheels of drive ГРМ
      Replacement of a forward epiploon (ов) a cranked shaft / of camshafts
      Replacement of a back epiploon of a cranked shaft
      Removal and installation of camshafts and pushers of valves
      Removal and installation of heads of cylinders
      Removal and pallet installation картера the engine
      Removal, check of a condition and installation of the oil pump
      Removal and installation приводного a disk
      Check of a condition and replacement of support of an engine mount
   + Procedures of service of the diesel engine
+ Systems of cooling of the engine, salon and air conditioning heating
+ The power supply system and release of the fulfilled gases
+ Engine electric equipment
+ Control systems of the engine and decrease in toxicity of the fulfilled gases
+ Gear change box
+ Transmissionnaja line
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment

Removal and installation of final collectors

Start procedure performance only after definitive cooling of the power unit.

Linings of final system to use it is repeatedly inadmissible. Company Toyota orders also replacement of nuts of fastening with the new.



1. Disconnect a negative wire from the battery.

If the stereosystem established on the car is equipped by a security code before to disconnect the battery make sure that have a correct combination for audiosystem input in action!

2. Impregnate fixture of collectors with getting oil, then give nuts of fastening of the reception pipe connecting a final collector with the catalyst.
3. Disconnect an electric socket of a ljambda-probe.
4. Give small bolts of fastening of the heat-shielding screen to a collector.
5. Give eight nuts and remove a collector from a head of cylinders. A lining will throw out.


Final collectors and labels of linings


1. Installation is made in an order, the return to an order of dismantle of components. Examine a new lining between a collector and a head. Original linings Toyota have the labels put by a white paint. Linings are established by labels to a collector. Track correct installation of a lining (address to an illustration above).
2. Establish a collector with a new lining, combining hairpins with a reception pipe. The new lining between a reception pipe and a collector Is required also. For installation use new nuts and tighten them with effort of 44 Nanometers.
3. Establish the heat-shielding screen and tighten four bolts with effort of 7.5 Nanometers.
4. Tighten nuts of fastening of a reception pipe to a collector with effort of 62 Nanometers.
5. Start the engine and check up it on presence of signs of leaks of the fulfilled gases.