Toyota Land Cruiser 100 / Amazon, Lexus LX 470

Since 1997 of release

Repair and car operation

Removal and installation of panels of an internal upholstery of doors

In order to avoid reception of cuts of hands about edges of technological windows in a doorframe work in gloves!

Removal

PERFORMANCE ORDER

1. On the models equipped with the electric drive стеклоподъемников, disconnect a negative wire from the battery.

If the stereosystem established on the car is equipped by a security code before to disconnect the battery make sure that have a correct combination for audiosystem input in action!

2. On models with a manual drive стеклоподъемников remove the regulator handle (address to an accompanying illustration), for отпускания a ring clamp get rags edge between the handle and the door panel (it is alternatively possible to take advantage of a suitable hook).

3. Remove a door armrest, if necessary having removed plastic заглушки. At a corresponding complete set remove the management handle a door mirror, remove an internal overlay of fastening of a door mirror.

4a. Turn out the screw. Remove assemblage of the internal handle, having shifted it forward (address to an accompanying illustration).

4b. Remove assemblage of the internal handle, having shifted it forward (address to an accompanying illustration).

5. On the models equipped электроприводными with steklopodemnikami/activators of the uniform lock accurately having hooked, liberate from an armrest of a door the panel of operating switches. Disconnect from the panel electroconducting.

6. On the majority of updatings of considered models one of screws of fastening of the panel of an internal upholstery of a door is under a rear-view mirror support. One more screw is located or hardly more low, or in a back top corner of the panel (address to an accompanying illustration). Bolts are under plastic заглушками.

7a. On some models it is necessary to remove the decorative panel of furnish of a support of a door mirror (see Has undressed Removal and installation of external rear-view mirrors). For branch of the panel of an internal upholstery of a door release the clamps located on its perimetre (address to an illustration to paragraph 6), hooking panel edges.

7b. For fastening of panels of an upholstery of back doors two lateral clamps, two screws and seven more clamps, located along external edge of the panel (address to an accompanying illustration) are used.

8. Cautiously separate polyethylene влагозащитную a film, having liberated two plugs through passage (address to an accompanying illustration).

Installation

PERFORMANCE ORDER

1. Track correctness of installation влагозащитного the screen. In case of need restore integrity of the torn screen by means of an adhesive tape. In case of need take advantage for подклеивания screen edges of silicone hermetic. Establish into place plugs through passage, clamps and the other fixing elements which have dropped out in the course of dismantle of an upholstery.
2. Get the panel of an internal upholstery of a door on the regular place and accurately latch all provided clamps. Where it is required, screw fixing screws.
3. The further installation is made upside-down.