Toyota Land Cruiser 100 / Amazon, Lexus LX 470

Since 1997 of release

Repair and car operation

Gin

Removal, installation and adjustment of a door of a back

In view of relevancy of weight of assemblage of a door of a back it will be reasonable to secure with the help of the assistant.

Design of a door of a back


1 — the Regulator стеклоподъемника 2 — Right directing стеклоподъемника 3 — a door Emphasis 4 — Back glass 5 — Left directing стеклоподъемника 6 — the door Lock 7 — the Directing tape of facing of a window aperture 8 — the External sealing tape	9 — the Cover of a service aperture 10 — the Plate 11 — the Cranked lever of a drive of a latch 12 — the lock Cylinder 13 — the Internal sealing tape 14 — the Facing panel of licence plate 15 — the Panel of an upholstery of a door of a back

PERFORMANCE ORDER

1. Disconnect a negative wire from the battery.

If the stereosystem established on the car is equipped by a security code before to disconnect the battery make sure that have a correct combination for audiosystem input in action!

2. Open a door of a back and reliably fix it in the lifted position. Remove a door emphasis (address to an illustration above).
3. Disconnect the electroconducting laid between a door of a back and a body of the car. For this purpose liberate the plug through passage and disunite contact sockets.

4. Lead round loopy laths a marker and turn out bolts of their fastening (address to an accompanying illustration). By means of the assistant remove assemblage of a door of a back from the car.

5. Installation is made upside-down.

6a. For lock replacement it is necessary to remove the panel of an internal upholstery of a door, the cover of a service window directing a tape of facing of a window aperture, a facing, sealing tape, glass, a regulator стеклоподъемника and directing a trench (see Has undressed Removal and installation has flown down also a regulator стеклоподъемника back doors). Remove the cranked lever of a remote drive of a latch of a door-lock (address to an accompanying illustration).

6b. Remove приводной the mechanism. The facing panel of licence plate fastens to a door of a back of the car by means of a nut and five clamps, give a nut and, hooking the panel, release clamps. Give two fixing nuts and remove the cylinder замковой assemblages, in case of need having disconnected corresponding electroconducting. Walk on an executive rod and disconnect it, also disconnect a drive cable отпускания the lock (address to an accompanying illustration).

6c. Turn out three fixing bolts (address to an accompanying illustration) and remove assemblage of a latch of the lock of a door. Installation is made upside-down.

7a. Door displacement in a longitudinal direction is made by отпускания nuts of fastening of loopy laths to a car body (address to an accompanying illustration), further loops подстукиваются by a hammer in the corresponding party.

7b. Adjustment of position of a door in кузовном an aperture (to the right-to the left, upwards-downwards) is made by easing of fixture of loops on a doorframe. Serviceability of operation of a latch is reached at the expense of updating of position of its drummer (address to an accompanying illustration). Having finished adjustment, strongly tighten corresponding fixture.