Toyota Land Cruiser 100 / Amazon, Lexus LX 470

Since 1997 of release

Repair and car operation


Tojota Lend Kruzer, Amazon, Leksus LX470
+ Identification numbers of the car
+ Controls and receptions of safe operation of the car
+ Options and car routine maintenance
+ The engine
+ Systems of cooling of the engine, salon and air conditioning heating
+ The power supply system and release of the fulfilled gases
+ Engine electric equipment
+ Control systems of the engine and decrease in toxicity of the fulfilled gases
+ Gear change box
+ Transmissionnaja line
- Brake system
   Specifications
   System of antiblocking of brakes (ABS) - the general information and codes of malfunctions
   Replacement brake колодок
   Removal and installation of supports of disk brake mechanisms
   Condition check, removal and installation of a brake disk
   Removal and installation of the main brake cylinder (ГТЦ)
   Check of a condition and replacement of brake lines and hoses
   The valve sensitive to loading/perepusknoj (LSP and BP)
   Adjustment of a lay brake
   Replacement of cables of a drive of a lay brake
   Check of serviceability of functioning / of tightness, removal and installation of the amplifier of brakes
   Prorolling of brake system
   Adjustment of a pedal of a foot brake
   Check of serviceability of functioning and replacement of the gauge-switch of stoplights
   Gauges and system ABS activator
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment





Replacement of cables of a drive of a lay brake

Components of assemblage of a lay brake

1 — the Pin
2 — the Cranked lever of a drive of a lay brake
3 — the Clip
4 — Shplint
5 — the Spring
6 — the Cover of the cranked lever
7 — the Arm of the cranked lever
8 — the Cable of a lay brake
9 — the Internal cable of a lay brake
10 — the Intermediate lever
11 — the Adjusting washer
12 — the Lock ring

13 — the Back disk brake mechanism
14 — the Returnable spring
15 — the Lobby колодка
16 — Raspornaja a plate
17 — Back колодка
18 — the Clamping spring
19 — the Brake disk
20 — the Lining
21 — the Regulator
22 — spring Saddles
23 — the Holder колодки


Components of assemblage of a lay brake are shown on an illustration above.

 PERFORMANCE ORDER

1. Release a lay brake. Ослабьте nuts of fastening of back wheels. Поддомкратьте the car also establish it on props. Remove wheels.
2. For выбирания a weak point приводного a cable ослабьте an adjusting nut (the Section Adjustment of a lay brake see).
3. Disconnect a cable from the cranked lever of a drive of a lay brake.
4. Disconnect an internal cable from the intermediate lever.
5. Liberate all cables from intermediate clamps on a bridge frame/kartere.
6. Installation is made upside-down.
7. Having finished installation, make adjustment of a drive of a lay brake.
8. Clean props and lower the car on the earth.