Toyota Land Cruiser 100 / Amazon, Lexus LX 470

Since 1997 of release

Repair and car operation


Tojota Lend Kruzer, Amazon, Leksus LX470
+ Identification numbers of the car
+ Controls and receptions of safe operation of the car
+ Options and car routine maintenance
+ The engine
+ Systems of cooling of the engine, salon and air conditioning heating
+ The power supply system and release of the fulfilled gases
+ Engine electric equipment
+ Control systems of the engine and decrease in toxicity of the fulfilled gases
+ Gear change box
+ Transmissionnaja line
- Brake system
   Specifications
   System of antiblocking of brakes (ABS) - the general information and codes of malfunctions
   Replacement brake колодок
   Removal and installation of supports of disk brake mechanisms
   Condition check, removal and installation of a brake disk
   Removal and installation of the main brake cylinder (ГТЦ)
   Check of a condition and replacement of brake lines and hoses
   The valve sensitive to loading/perepusknoj (LSP and BP)
   Adjustment of a lay brake
   Replacement of cables of a drive of a lay brake
   Check of serviceability of functioning / of tightness, removal and installation of the amplifier of brakes
   Prorolling of brake system
   Adjustment of a pedal of a foot brake
   Check of serviceability of functioning and replacement of the gauge-switch of stoplights
   Gauges and system ABS activator
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment





The valve sensitive to loading/perepusknoj (LSP and BP)

The centre of gravity of lorries is located above, than at automobile, besides, on the unloaded car it is considerably shifted forward. During braking the combination of the listed factors leads to that the basic loading is necessary on forward wheels while back considerably unload. Thus, hydraulic pressure in a forward brake contour should be appreciable above, than in back (otherwise back wheels at sharp braking will be blocked prematurely).

At loading the truck centre of gravity is displaced in its back part that demands corresponding redistribution of brake efforts. The given function is carried out by the valve sensitive to loading/perepusknoj (LSP and BP) (address to an accompanying illustration).

In view of that for adjustment and service LSP and BP the special measuring equipment is required, it is necessary to charge performance of the given work to experts of car-care centre. Nevertheless, valve replacement can be quite made own forces of the owner of the car (for adjustment LSP and BP the car nevertheless should be driven away on a car repair shop). At removal of the back bridge it is necessary also not to forget to disconnect from it a rod of monitoring of road gleam LSP and BP (if other installations of the valve did not change the rod detachment should not lead to infringement of adjustments).

Removal and installation

Details of installation of valve LSP and BP


After performance of replacement of the valve the car should be driven away on a car repair shop for performance of adjustment LSP and BP.


 PERFORMANCE ORDER

1. Поддомкратьте the car also establish it on props.
2. Ослабьте накидные nuts штуцерных connections of brake lines on assemblage of valve LSP and BP (address to an illustration above), take advantage special накидным of a key with a cutting head. Accurately disconnect hydraulic lines, at once закупорьте their open ends.
3. Give a counternut and disconnect an adjusting bolt from the lever of a back suspension bracket.
4. Turn out fixing bolts and remove valve LSP and BP in gathering with the basic arm.
5. Give fixing nuts and remove клапанную assemblage from a basic arm.
6. Installation is made upside-down. Track correctness of installation of initial length of a spring and reliability of a tightening of a counternut (address
To an accompanying illustration).
7. Pump over brake system (the Section Prorolling of brake system see).
8. Drive away the car on a car repair shop for the purpose of performance of adjustment LSP and BP.