Tojota Lend Kruzer, Amazon, Leksus LX470
+ Identification numbers of the car
+ Controls and receptions of safe operation of the car
+ Options and car routine maintenance
+ The engine
+ Systems of cooling of the engine, salon and air conditioning heating
+ The power supply system and release of the fulfilled gases
+ Engine electric equipment
+ Control systems of the engine and decrease in toxicity of the fulfilled gases
+ Gear change box
+ Transmissionnaja line
- Brake system
Specifications
System of antiblocking of brakes (ABS) - the general information and codes of malfunctions
Replacement brake колодок
Removal and installation of supports of disk brake mechanisms
Condition check, removal and installation of a brake disk
Removal and installation of the main brake cylinder (ГТЦ)
Check of a condition and replacement of brake lines and hoses
The valve sensitive to loading/perepusknoj (LSP and BP)
Adjustment of a lay brake
Replacement of cables of a drive of a lay brake
Check of serviceability of functioning / of tightness, removal and installation of the amplifier of brakes
Prorolling of brake system
Adjustment of a pedal of a foot brake
Check of serviceability of functioning and replacement of the gauge-switch of stoplights
Gauges and system ABS activator
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
|
Check of serviceability of functioning and replacement of the gauge-switch of stoplights
Check
|
|
1. The Gauge-switch of stoplights is fixed on a basic arm of a pedal of a foot brake (address to an illustration Adjusting height of a pedal of a foot brake in the released condition). For the purpose of providing of access remove the furnish panel under a steering column (the Body see the Head).
2. At completely released pedal the gauge-switch is in the opened position. Already weak squeezing of a pedal leads to short circuit of the gauge-switch and operation of stoplights.
3. If serviceability of operation of stoplights is broken, first of all check up a condition of a corresponding safety lock (the Onboard electric equipment see) and incandescent filaments of lamps.
4. If the safety lock and lamps is perfectly in order, check up food presence on the gauge-switch.
5. If food giving on the gauge-switch is broken, check up on presence of signs of breakage electroconducting on a chain site between the assembly block of safety locks and the gauge-switch. If a food moves regularly, close the gauge-switch (squeeze out a pedal of a foot brake) and check up it on presence of target pressure.
6. If target pressure on the gauge-switch is absent, it is necessary to make assemblage replacement, otherwise check up an electroconducting condition on a chain site between the gauge-switch and lamps of stoplights (the Onboard electric equipment see). |
|
Replacement
|
|
1. Remove the finishing panel established under a steering column (the Body see the Head).
2. Disconnect from the gauge-switch of stoplights electroconducting.
3. Give the bottom counternut of the gauge-switch.
4. Remove the gauge-switch from a basic arm.
5. Installation is made upside-down. Having finished, make gauge-switch adjustment (see Has undressed Gauges and system ABS activator). |
|
|
|