Tojota Lend Kruzer, Amazon, Leksus LX470
+ Identification numbers of the car
+ Controls and receptions of safe operation of the car
+ Options and car routine maintenance
+ The engine
+ Systems of cooling of the engine, salon and air conditioning heating
+ The power supply system and release of the fulfilled gases
+ Engine electric equipment
+ Control systems of the engine and decrease in toxicity of the fulfilled gases
+ Gear change box
+ Transmissionnaja line
- Brake system
Specifications
System of antiblocking of brakes (ABS) - the general information and codes of malfunctions
Replacement brake колодок
Removal and installation of supports of disk brake mechanisms
Condition check, removal and installation of a brake disk
Removal and installation of the main brake cylinder (ГТЦ)
Check of a condition and replacement of brake lines and hoses
The valve sensitive to loading/perepusknoj (LSP and BP)
Adjustment of a lay brake
Replacement of cables of a drive of a lay brake
Check of serviceability of functioning / of tightness, removal and installation of the amplifier of brakes
Prorolling of brake system
Adjustment of a pedal of a foot brake
Check of serviceability of functioning and replacement of the gauge-switch of stoplights
Gauges and system ABS activator
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
|
Condition check, removal and installation of a brake disk
Condition check
|
|
1. Ослабьте nuts of fastening of wheels, cock a lay brake, поддомкратьте the car and establish it on props. Remove a corresponding wheel.
2. Remove a brake support (see Has undressed Removal and installation of supports of disk brake mechanisms) and tie up it aside a wire to a suspension bracket element, without disconnecting a brake hose, try, that the hose has not appeared will pull or is overwound.
3. Make visual check of a condition of both working surfaces of a disk. Easy defects can be eliminated by means of a fine-grained emery paper. For removal of furrows by depth more a disk it is necessary to remove and subject than 0.4 mm проточке. Remember that disk survey should be made from its both parties!
|
|
4. If during braking pedal pulsations were noticed, it is necessary to estimate size of lateral palpation of a brake disk. Fix циферблатный a measuring instrument плунжерного type (DTI) on distance about 12.7 mm from external edge of a disk (address to an accompanying illustration). Null the device and start to rotate a disk. The result of measurement should not fall outside the limits the admissible range stipulated in Specifications, otherwise it is necessary to give a disk in проточку.
|
|
Composers of the present Management recommend to make проточку disks without dependence from their condition for the purpose of removal from working any surfaces of defects. As a last resort it is possible to be limited to processing of a disk by a fine-grained emery paper. |
|
5. At проточке a disk it is necessary to give particular attention to observance of requirements of Specifications to its minimum admissible thickness, on a face surface of a disk corresponding marks are provided. Measurement of a thickness of a disk is made in several points by means of a micrometer. |
|
Removal and installation
|
|
1. Remove from a rotary fist gauge ABS.
2. Remove brake колодки and a support.
3. Remove assemblage of a nave and separate it from a brake disk.
4. Carefully wash out and examine components of assemblage of a disk/nave.
5. Make nave assemblage, establish it on the regular place and make adjustment of a pretightness of the wheel bearing.
6. Establish into place assemblage of a support with brake колодками (see Has undressed Removal and installation of supports of disk brake mechanisms) and pump over brake system (the Section Prorolling of brake system see).
7. Establish wheels, lower the car on the earth and tighten wheel nuts with demanded effort (see the Head of Adjustment and car routine maintenance). |
|
|
|