Removal and installation of a bar of the back stabilizer of cross-section stability
Components of installation of the back stabilizer of cross-section stability
|
|
1. Components of installation of the stabilizer of cross-section stability are presented on an illustration above.
2. Prop up forward wheels противооткатными boots. Поддомкратьте a back of the car also establish it on props.
|
|
3. Give fixing bolts and nuts and remove both racks of the stabilizer (address to an accompanying illustration). |
|
|
4. Turn out bolts of arms of fastening of a bar (address to an accompanying illustration). |
5. Remove a bar of the stabilizer of cross-section stability from the car.
6. Estimate a condition of rubber plugs, defective components replace.
7. Installation is made upside-down. Track, that all fixture has been tightened with demanded effort. |
|
|