Toyota Land Cruiser 100 / Amazon, Lexus LX 470

Since 1997 of release

Repair and car operation

Removal and installation of the steering mechanism

Models of cars considered in the present Management are equipped by system of additional safety (SRS). Before to start performance of any works near to the block of a pillow of safety, a steering column or the instrument panel, disconnect SRS in order to avoid reception of traumas at its casual operation (the Onboard electric equipment see). Electroconducting of chain SRS is easy for distinguishing on yellow colour of isolation. In order to avoid system SRS damage, Track, that the steering shaft was not turned after steering wheel removal. Block a column the ignition key at rectilinear position of forward wheels.

Components of assemblage of the steering mechanism

Components of installation of the steering mechanism

PERFORMANCE ORDER

1. Park the car with the forward wheels developed in rectilinear position. Cock a lay brake. Ослабьте wheel nuts, поддомкратьте redock of the car also establish it on props. Remove forward wheels and protection картера.
2. Disconnect lateral steering draughts from rotary fists (the Section condition Check, removal and installation of draughts of a steering drive see).
3. Remove a bar of the stabilizer of cross-section stability (see Has undressed Removal and installation of the forward stabilizer of cross-section stability).
4. Mark position of an intermediate shaft concerning the steering mechanism and turn out a through bolt connecting карданного the hinge of a steering shaft.
5. Disconnect from картера the steering mechanism pressure head and returnable lines of a hydraulic path (address to an illustration Components of assemblage of the steering mechanism).
6. Turn out fixture (With and D) assembly скобы on the right side of assemblage, give a nut and take a through bolt (B) at the left. In summary turn out a bolt (A) (address to an illustration Components of installation of the steering mechanism).
7. Remove assemblage of the steering mechanism from the car.
8. If at the removed steering mechanism for any reason it has been made проворачивание a steering shaft, remove a steering wheel and centre a contact drum of a pillow of safety (see Has undressed Removal and steering wheel installation).
9. Installation is made upside-down. Track that all fixture has been tightened with demanded effort.
10. In summary pump over system GUR (see Has undressed Removal of air from a hydraulic path of system of strengthening of a wheel).