Tojota Lend Kruzer, Amazon, Leksus LX470
+ Identification numbers of the car
+ Controls and receptions of safe operation of the car
+ Options and car routine maintenance
+ The engine
+ Systems of cooling of the engine, salon and air conditioning heating
+ The power supply system and release of the fulfilled gases
+ Engine electric equipment
+ Control systems of the engine and decrease in toxicity of the fulfilled gases
+ Gear change box
+ Transmissionnaja line
+ Brake system
- Suspension bracket and steering
Specifications
Removal and installation of forward shock-absorbers
Removal and installation of the forward stabilizer of cross-section stability
Removal and installation of assemblage of a rotary fist from a nave
Check of a condition and replacement of spherical support
Removal and installation торсионных bars
Removal and installation of the top operating lever of a forward suspension bracket
Removal and installation of the bottom operating lever of a forward suspension bracket
Removal and installation of back shock-absorbers
Removal and installation of a bar of the back stabilizer of cross-section stability
Removal and installation of a jet bar
Removal and installation of a screw spring of a back suspension bracket
Removal and installation of levers of a back suspension bracket
Removal and steering wheel installation
Condition check, removal and installation of draughts of a steering drive
Replacement of protective covers of assemblage of the steering mechanism
Removal and installation of the steering mechanism
Removal and installation of the steering pump
Removal of air from a hydraulic path of system of strengthening of a wheel
Wheels and tyres - the general information
Corners of installation of wheels
+ Body
+ Onboard electric equipment
|
Removal and installation of assemblage of a rotary fist from a nave
|
|
Remember that developed in the course of work of brake mechanisms the dust can contain extremely unhealthy the person asbestos. At all do not blow off a dust the compressed air and do not inhale it, at service of mechanisms put on a protective mask or a respirator. Do not use for rubbing of components of brake system gasoline or solvents on an oil basis, apply only firm cleaners or methyl spirit!
|
Nave of a forward suspension bracket
|
|
1. Cock a lay brake. Ослабьте nuts of fastening of a corresponding forward wheel, поддомкратьте redock of the car also establish it on props. Remove a wheel.
2. Disconnect from a rotary fist a basic arm of a brake hose and the other lines of communication provided by a complete set (address to an illustration above). On equipped ABS models remove from fist assemblage the wheel gauge (the Brake system see the Head).
3. Remove assemblage of a nave with a brake disk (the line see Head Transmissionnaja).
5. Remove брызгоотбойник a brake disk (the Brake system see the Head).
6. Remove an epiploon, a lining and пыльник (address to an illustration above).
7. Disconnect from a rotary fist a tip of steering draught (the Section condition Check, removal and installation of draughts of a steering drive see).
8. Поддомкратьте the bottom lever of a suspension bracket also disconnect it from a rotary fist.
9. Remove шплинт and give a nut.
10. Disconnect a rotary fist from the top lever.
11. Remove a rotary fist from the bottom lever.
12. Installation is made upside-down. Track, that all fixture has been tightened with demanded effort. |
|
|
|