1. After performance of any procedures connected with a detachment of lines of system of hydrostrengthening of a wheel, it is necessary to remove air from hydraulic path ГУР. Otherwise efficiency of functioning of the steering amplifier appreciably will decrease.
2. Develop forward wheels of the car in rectilinear position and check up liquid level in system GUR tank (see the Head of Adjustment and car routine maintenance). In case of need make corresponding updating (liquid level should reach the bottom point COLD in a tank wall).
3. Start the engine and leave its working on 1000 rpm. Once again check up liquid level in tank GUR. In case of need again make updating.
4. Steering wheel rotation here and there (without blows in the course ends) remove from system air (watch that liquid level in the tank during prorolling did not fall below an admissible limit).
5. Having finished prorolling, return wheels in rectilinear position, allow to the engine to work within even several minutes, then muffle it.
6. Make car trial runs, checking serviceability and noiselessness of functioning of steering system.
7. Once again check up level of a hydraulic liquid at the heated-up engine to normal working temperature (this time it should reach a mark of NOTES in a tank wall). In case of need make necessary updating (see the Head of Adjustment and car routine maintenance). |
|